Shelving Rack & Lockers, Inc. has specialized in Warehouse Space Control since 1989. We maintain a large local stock of new and used storage equipment products from Ridg-U-Rak, Lyon, Penco, Akro-Mils, Rubbermaid, Louisville Ladders, J&L Wire Products, and more. Shelving Rack & Lockers is your one stop shopping source for all your storage equipment needs! We welcome orders of all sizes - small or large. Member of the Better Business Bureau. Locker Colorado
I purchased 10 kits for a back to school party for middle school girls. They were a big hit. The girls loved decorating the frames and magnets. The parents especially liked a craft that was actually useful. The girls are using them in their school lockers. Overall the product is well made. You can use either the mirror or dry erase side. If you change your mind later you can switch sides. Locker
Steel thickness: lockers tend to be made from a standard thickness of steel, which is commonly 0.8 mm. thick; but heavy-duty or high-security lockers are offered as a standard option by some manufacturers, or may be available on special order. A typical locker of this sort may be constructed from steel 1.2 mm. thick, for example, and is usually fitted with three-point locking, regardless of the number of tiers. School Locker

Number of locking points: Locker doors may lock with either single- or three-point locking, but this is not normally chosen as a separate option, and the choice is usually dependent on the number of tiers in the lockers, or whether they are a high-security model, although some manufacturers do allow purchasers to specifically choose an option here that goes against their normal practice. Single-point locking locks the door at only the point where the latch engages with the door-frame, whereas three-point locking uses extensible steel rods to lock the top and bottom of the door as well. Locker CO

I've got pencils and a whole lot of them... I have 144 Colore HB #2 pencils. 100% wood and non-toxic. I work in the elementary school system and there is always a shortage of pencils. I bought this box to donate to my school but first I wanted to try one out. I like! On a daily basis I am sharpening pencils. This is one clue as to how good the pencil is. If the lead falls out or even looks loose then it's not that good. I immediately sharpened a pencil and wrote with it. It was the greatest. It stayed within the casing and wrote very good. The eraser was soft and erased easily. Another clue a good pencil from a bad pencil; the eraser. This eraser looks hard but is quite soft. It erased smoothly. What more can you say about a pencil? A ... full review Locker Colorado
Quality Refurbishing Many of the old, wholesale lockers we have in stock have minimal damage and some are near brand-new condition. For lockers that need repairs, our unique multiple point inspection and repair process helps to refine these lockers to a high quality, salvaged state. We know you want to buy quality lockers and we will not be shipping out lockers that are not fully functional. To get the most out of your refurbished locker, we also offer tips on alternative ways you can utilize them. Don't want to have the same old wall locker look? Use one as a laundry room locker or a console table. Locker
From our base in Denver, CO, Shelving Rack & Lockers, Inc. has been providing quality products such as pallet storage racks, industrial shelving, lockers, and allied products to customers in Colorado and nationwide since 1989. We carry a full line of industrial storage equipment from quality manufacturers. Our experienced staff can assist you in every aspect of your storage needs, from design through installation.

I purchased 10 kits for a back to school party for middle school girls. They were a big hit. The girls loved decorating the frames and magnets. The parents especially liked a craft that was actually useful. The girls are using them in their school lockers. Overall the product is well made. You can use either the mirror or dry erase side. If you change your mind later you can switch sides. Locker CO

Division 10 — Specialties Lockers: Division 10 — Specialties is a category within the National Master Specification (NMS) set of guidelines developed by Public Works and Government Services Canada. Division 10 — Specialties items that could be required within a locker room (to meet commercial building and construction regulations) are lockers, washroom accessories, toilet compartments, and toilet partitions. Lockers are constructed of two sides: a back, top and a bottom. Different types of materials are used in locker manufacturing, offering a wide variety of metal lockers, stainless steel lockers, solid plastic lockers, solid phenolic lockers, and custom lockers. A padlock is the most common way to lock a locker; however, you can also use a keyed cylinder lock, built in combination locks or keypad locks. There are a lot of optional extras that can be utilized for lockers, for example: bases, sloping tops, end panels, customized shelves and hooks as well as the locking method (coin-operated lockers are another option). The environment is the best way to distinguish what type of locker will be required for which type of space. For example, if you are putting gym lockers into a humid area, or anywhere close to showers, stainless steel or solid plastic lockers would be most suitable because they are moisture-resistant and rust-resistant. Wood lockers would not be appropriate for this type of environment because the moisture from the humidity would rot the wood.
Clean/dirty lockers normally have two or three parts within the locker. One part is meant for dirty or clothes that are worn, and the other side for clean clothes. These lockers are meant for hospitals or other medical workplaces where it is useful to keep work and personal clothes apart to reduce the risk of infection. These lockers are also useful for factories where work clothes can become dirty and it can be very useful to keep them apart from personal clothes. Locker CO
Unlike our competitors, we make it a point to refurbish all of our used lockers so that we can deliver a quality product for the cheaper price you want. With warehouses on the East and West coasts, we're able to store several lockers so that we can bring you the best selection possible. Find the shape, color, and size that works best for you with just a few clicks. Our site is simple to navigate, easing the process of buying so that you can spend more time on the things that matter to you. Need help? We're just a call or an email away and we're always happy to assist you at any stage of your buying process.

I have 4 kids under age 5 and was constantly bothered by their coats and shoes being lost all over the house. This has been fantastic for organizing all their hats, gloves, shoes, boots, coats, jackets, backpacks, etc. It has held up very well despite being packed with more than I ever expected to fit in it. The kids know as soon as they walk in the door to go hang up their coats and backpacks and to put their shoes in their cubbies. I anticipate being able to use this for at least 10 years to come. It's incredibly sturdy and well-made. My husband assembled it in less than an hour and the directions were very clear. Locker Colorado
I have 4 kids under age 5 and was constantly bothered by their coats and shoes being lost all over the house. This has been fantastic for organizing all their hats, gloves, shoes, boots, coats, jackets, backpacks, etc. It has held up very well despite being packed with more than I ever expected to fit in it. The kids know as soon as they walk in the door to go hang up their coats and backpacks and to put their shoes in their cubbies. I anticipate being able to use this for at least 10 years to come. It's incredibly sturdy and well-made. My husband assembled it in less than an hour and the directions were very clear. School Locker
Rebecca, I remember a previous post that a visitor found storage at the bus station, so I called to see if still available, and it is. Lockers are $3 for the first hour and $1 per hour after that. It's difficult to find storage short term because of security/liability, esp. since 9/11. If you are staying at a hotel, they will often keep your luggage for you short term. Locker
Material: steel is the traditional material; but wood, plastic, or laminate are sometimes used. Plastic or laminate lockers are sometimes advocated in environments, such as near swimming pools, where moisture accumulation may cause steel lockers to rust over time. They can also be used in external applications where internal space is not available. Locker Colorado
Tiers: may be specified as single-tier (full height), two-tier, three-tier, etc., meaning that the lockers are stacked on top of each other in layers two high, three high, etc. Tiers are commonly up to eight high; on occasion, even more tiers may be found, in the case of very small lockers for such purposes as storing laptop computers. The most common numbers of tiers found in lockers are, in order, one, two, and four; three-tier lockers are rather less common, and other numbers such as five, six, or eight even less common still - seven almost non-existent. Since locker cabinets are most commonly 6 feet (182.9 cm.) high (although there are exceptions), the height of individual lockers varies according to how many tiers are accommodated within the cabinet. The height of individual lockers is usually approximately 6 feet (182.9 cm.) divided by the number of tiers, so that two-tier lockers are about 3 feet (91.4 cm.) high, three-tier lockers 2 feet (61 cm.) high, four-tier lockers 1.5 feet (45.7 cm.) high, and so on. Standard features often vary according to the number of tiers: single-tier lockers usually include a shelf about a foot (roughly 30 cm.) from the top, and a hanging rail (sometimes with one or two hooks) immediately underneath that, at the top of the large compartment beneath the shelf; two- or three-tier lockers usually lack the shelf, but include the hanging rail; lockers with four or more tiers usually have none of these fittings, but consist of just the bare compartment. School Locker
Problems donating? | Other ways to give | Frequently asked questions | We never sell your information. By submitting, you are agreeing to our donor privacy policy. The Wikimedia Foundation is a nonprofit, tax-exempt organization. The Wikimedia Endowment provides dedicated funding to realize the power and promise of Wikipedia and related Wikimedia projects for the long term. For more information, visit wikimediaendowment.org.
Operating in over 600,000 square feet, Salsbury Industries offers a complete line of metal lockers, vented lockers, extra wide lockers, modular lockers, wood lockers, plastic lockers, storage lockers, storage cabinets, storage shelving and benches. Most items ship within 1-2 business days from the date an order is received. Whether you are located around the block or around the world, you can count on Salsbury Industries to deliver quality products on time from our distribution facilities in Los Angeles, California. Locker CO
Gun lockers or safes are specifically designed for the secure storage of guns and ammunition. They broadly resemble normal single-tier lockers, but tend to be slightly less high than normal single-tier lockers, and are often free-standing, and not banked together. They are fitted with internal racks designed for holding firearms. They have a shelf at the top like normal single-tier lockers, although in this case it is closed and locked by a separate door, because of legal requirements in some countries that firearms and ammunition be stored and locked separately. They always lock with three-point locking, which is in some countries a legal requirement for the storage of firearms. Sometimes they are made of the standard kind of sheet steel used in manufacturing normal lockers, and sometimes they are made of extremely thick heavy-duty steel and in this case resemble a safe more than a normal locker. In Australia there are strict regulations governing the storage of firearms following the Port Arthur massacre in Tasmania, Australia on 28 April 1996, and cabinets used for storing firearms must be bolted to the floor or a wall if the cabinet is under a certain weight. Dedicated gun lockers are likely to include holes in the cabinet to accommodate such bolting. Several locker manufacturers also offer dedicated gun lockers. School Locker
In schools without lockers, students are sometimes provided with two complete sets of textbooks, one set being kept at school for use in class, and the other being kept at home for referring to for homework, thus limiting the amount of heavy carrying that would otherwise be required without having lockers to store them in between classes.[1] However, research has shown an increase in the incidence of back injuries in some students, which has been directly attributed to the lack of lockers for storing books in, thus forcing students to spend more time carrying heavy loads of books in backpacks.

Gun lockers or safes are specifically designed for the secure storage of guns and ammunition. They broadly resemble normal single-tier lockers, but tend to be slightly less high than normal single-tier lockers, and are often free-standing, and not banked together. They are fitted with internal racks designed for holding firearms. They have a shelf at the top like normal single-tier lockers, although in this case it is closed and locked by a separate door, because of legal requirements in some countries that firearms and ammunition be stored and locked separately. They always lock with three-point locking, which is in some countries a legal requirement for the storage of firearms. Sometimes they are made of the standard kind of sheet steel used in manufacturing normal lockers, and sometimes they are made of extremely thick heavy-duty steel and in this case resemble a safe more than a normal locker. In Australia there are strict regulations governing the storage of firearms following the Port Arthur massacre in Tasmania, Australia on 28 April 1996, and cabinets used for storing firearms must be bolted to the floor or a wall if the cabinet is under a certain weight. Dedicated gun lockers are likely to include holes in the cabinet to accommodate such bolting. Several locker manufacturers also offer dedicated gun lockers. Locker
×