If you’d like to make your new security system matching your cabinets, we can help you with décor ideas. Our products come in a wide variety of materials, colors and finishes. Our antique-styled cabinet locks will go perfectly in older, wooden furniture, and stainless-steel locks are ideal for steel filing cabinets. We even have store-quality locks for clear sliding-glass display cases. Locker CO
Tiers: may be specified as single-tier (full height), two-tier, three-tier, etc., meaning that the lockers are stacked on top of each other in layers two high, three high, etc. Tiers are commonly up to eight high; on occasion, even more tiers may be found, in the case of very small lockers for such purposes as storing laptop computers. The most common numbers of tiers found in lockers are, in order, one, two, and four; three-tier lockers are rather less common, and other numbers such as five, six, or eight even less common still - seven almost non-existent. Since locker cabinets are most commonly 6 feet (182.9 cm.) high (although there are exceptions), the height of individual lockers varies according to how many tiers are accommodated within the cabinet. The height of individual lockers is usually approximately 6 feet (182.9 cm.) divided by the number of tiers, so that two-tier lockers are about 3 feet (91.4 cm.) high, three-tier lockers 2 feet (61 cm.) high, four-tier lockers 1.5 feet (45.7 cm.) high, and so on. Standard features often vary according to the number of tiers: single-tier lockers usually include a shelf about a foot (roughly 30 cm.) from the top, and a hanging rail (sometimes with one or two hooks) immediately underneath that, at the top of the large compartment beneath the shelf; two- or three-tier lockers usually lack the shelf, but include the hanging rail; lockers with four or more tiers usually have none of these fittings, but consist of just the bare compartment. Locker CO
When looking at Pallet Racks as a storage solution, consider the needs along with the physical requirements of your business before investing in a complete pallet racking system. Industrial Storage Rack configurations should consider accessibility to individual loads (selectivity), handling time, the efficiency of space utilization (storage density), order fulfillment speed, along with acquisition expenses. Locker CO
Sloping tops: while most lockers have flat tops, some manufacturers offer the option of sloping tops to their range of lockers. The slope may be of either 30 degrees or 45 degrees to the horizontal, sloping towards the front, and the purpose of this is to make it impossible to store items on top of the lockers, or to make it harder for dust or other debris to accumulate there. This is an important factor in places like food-processing factories or restaurants where hygiene requirements must be met. Locker CO
Division 10 — Specialties Lockers: Division 10 — Specialties is a category within the National Master Specification (NMS) set of guidelines developed by Public Works and Government Services Canada. Division 10 — Specialties items that could be required within a locker room (to meet commercial building and construction regulations) are lockers, washroom accessories, toilet compartments, and toilet partitions. Lockers are constructed of two sides: a back, top and a bottom. Different types of materials are used in locker manufacturing, offering a wide variety of metal lockers, stainless steel lockers, solid plastic lockers, solid phenolic lockers, and custom lockers. A padlock is the most common way to lock a locker; however, you can also use a keyed cylinder lock, built in combination locks or keypad locks. There are a lot of optional extras that can be utilized for lockers, for example: bases, sloping tops, end panels, customized shelves and hooks as well as the locking method (coin-operated lockers are another option). The environment is the best way to distinguish what type of locker will be required for which type of space. For example, if you are putting gym lockers into a humid area, or anywhere close to showers, stainless steel or solid plastic lockers would be most suitable because they are moisture-resistant and rust-resistant. Wood lockers would not be appropriate for this type of environment because the moisture from the humidity would rot the wood. Locker Colorado
There are a number of features or characteristics which may vary in lockers. Because purchasers will need to specify what they want in each of these when ordering, it is more common to order a particular configuration rather than buy "off the shelf" in a shop, although certain very common configurations can be found in shops fairly easily. These features include: Locker Colorado
Gun lockers or safes are specifically designed for the secure storage of guns and ammunition. They broadly resemble normal single-tier lockers, but tend to be slightly less high than normal single-tier lockers, and are often free-standing, and not banked together. They are fitted with internal racks designed for holding firearms. They have a shelf at the top like normal single-tier lockers, although in this case it is closed and locked by a separate door, because of legal requirements in some countries that firearms and ammunition be stored and locked separately. They always lock with three-point locking, which is in some countries a legal requirement for the storage of firearms. Sometimes they are made of the standard kind of sheet steel used in manufacturing normal lockers, and sometimes they are made of extremely thick heavy-duty steel and in this case resemble a safe more than a normal locker. In Australia there are strict regulations governing the storage of firearms following the Port Arthur massacre in Tasmania, Australia on 28 April 1996, and cabinets used for storing firearms must be bolted to the floor or a wall if the cabinet is under a certain weight. Dedicated gun lockers are likely to include holes in the cabinet to accommodate such bolting. Several locker manufacturers also offer dedicated gun lockers. Locker
Laundry lockers are used in places like hospitals and food-processing workplaces where uniforms have to be collected, laundered, then returned to their owners. The locker cabinet contains a number of very narrow lockers, each of whose doors is keyed using a key held by the owner, so that they have access only to their own locker; but the entire array of doors is embedded in a much larger door covering the entire front of the cabinet. Opening this opens all the lockers simultaneously, and requires the use of a master key which is held by whoever collects items deposited in lockers, for laundering, then returned in the same way, after which they items are accessible to owners using their individual small doors. Locker Colorado
Number of locking points: Locker doors may lock with either single- or three-point locking, but this is not normally chosen as a separate option, and the choice is usually dependent on the number of tiers in the lockers, or whether they are a high-security model, although some manufacturers do allow purchasers to specifically choose an option here that goes against their normal practice. Single-point locking locks the door at only the point where the latch engages with the door-frame, whereas three-point locking uses extensible steel rods to lock the top and bottom of the door as well. School Locker
Lockers are usually physically joined together side by side in banks, and are commonly made from steel, although wood, laminate, and plastic are other materials sometimes found. Steel lockers which are banked together share side walls, and are constructed by starting with a complete locker; further lockers may then be adding by constructing the floor, roof, rear wall, door, and just one extra side wall, the existing side wall of the previous locker serving as the other side wall of the new one. The walls, floors, and roof of lockers may be either riveted together (the more traditional method) or, more recently, welded together. Locker CO
There are a number of features or characteristics which may vary in lockers. Because purchasers will need to specify what they want in each of these when ordering, it is more common to order a particular configuration rather than buy "off the shelf" in a shop, although certain very common configurations can be found in shops fairly easily. These features include:
Salsbury Industries offers a complete line of metal locker, steel locker, plastic locker, vented locker, wood locker and wire locker in a wide range of colors and styles, so you are sure to find the perfect locker that suits your needs. Our locker are used for a variety of applications such as employee locker, school locker, student locker, restaurant locker, day care locker, pool locker, gym locker, club locker, fire department locker, police locker, apartment lockers and home locker. We also offer a complete line of accessories including wood locker benches, aluminum locker benches, locker bases, side panels and locks to complete your project. Products shown on this site are manufactured and distributed by Salsbury Industries – Lockers.com. For more information please visit: LOCKERS.COM or call 1-800-LOCKERS (1-800-562-5377).
Lockers are usually physically joined together side by side in banks, and are commonly made from steel, although wood, laminate, and plastic are other materials sometimes found. Steel lockers which are banked together share side walls, and are constructed by starting with a complete locker; further lockers may then be adding by constructing the floor, roof, rear wall, door, and just one extra side wall, the existing side wall of the previous locker serving as the other side wall of the new one. The walls, floors, and roof of lockers may be either riveted together (the more traditional method) or, more recently, welded together.
Some schools in the United States have been reported to have abolished the use of lockers. Security concerns are cited as the reason for this, with the concern being that lockers may be used to store contraband items such as weapons or drugs or pornographic material. There has been some controversy over in what circumstances school authorities or law-enforcement officials are permitted to search lockers, with or without informing the users, or with or without the users being present at the time of the search, and it has been considered a civil liberties issue, particularly in the U.S. Locker CO
Unlike our competitors, we make it a point to refurbish all of our used lockers so that we can deliver a quality product for the cheaper price you want. With warehouses on the East and West coasts, we're able to store several lockers so that we can bring you the best selection possible. Find the shape, color, and size that works best for you with just a few clicks. Our site is simple to navigate, easing the process of buying so that you can spend more time on the things that matter to you. Need help? We're just a call or an email away and we're always happy to assist you at any stage of your buying process.
Material: steel is the traditional material; but wood, plastic, or laminate are sometimes used. Plastic or laminate lockers are sometimes advocated in environments, such as near swimming pools, where moisture accumulation may cause steel lockers to rust over time. They can also be used in external applications where internal space is not available. Locker CO
Terry, there are many storage unit places closer to the airport, but then of course you'd have to rent a car. DIA Self Storage, for example, is less than 10 miles away. You can google map Denver International Airport, then "search nearby" for "self storage units" if you think that's something you might want to do. http://www.coloradoselfstorage.com/ Locker CO
Quality Refurbishing Many of the old, wholesale lockers we have in stock have minimal damage and some are near brand-new condition. For lockers that need repairs, our unique multiple point inspection and repair process helps to refine these lockers to a high quality, salvaged state. We know you want to buy quality lockers and we will not be shipping out lockers that are not fully functional. To get the most out of your refurbished locker, we also offer tips on alternative ways you can utilize them. Don't want to have the same old wall locker look? Use one as a laundry room locker or a console table. Locker CO
Don't take chances with a small storage company that doesn't have the nationwide resources like CubeSmart to ensure that customer service is prioritized. We're in it for the long-haul and we recognize that your satisfaction is instrumental to our success. We think you should expect more from storage and our locations in and around Denver are ready to exceed your expectations. School Locker
Dimensions (Note that, in English-speaking countries, even those commonly using metric measurements now, locker dimensions are usually clean numbers of inches or feet, while the corresponding metric measurements are uneven, involving decimal places when precision is required, presumably resulting from continued use of locker designs based on feet and inches, unchanged for decades other than for cosmetic features.): Locker